After successful installation per your vid including your supplied thermal sensor connector, I have continuous running fan. It also has a temperature alarm that notifies you when temperatures go beyond safe levels. Bought the 1.0 Tb Seagate Desktop from your website (couldn’t find a 1.0 T Seagate Barracuda to match what’s in the Mac), and bought installation kit. Apple had the fan controls linked to a sensor in their old drive and when that drive is removed the fans go on full speed unless you do something to control them. It includes automatic and manual modes for controlling fan speeds. I installed a Solid State drive in my 2012 iMac and used this to allow automatic control of the cooling fans. I let the application start at log in, so once I log in, the fan stops after a moment (about 10 seconds i guess).Īnother solution is to order an ODD thermal sensor cable at apple components and stick it on the SSD and plug it into the HHD sensor connector on the logic board, it does the exact same thing as the original thermal sensor cable with the connector) That's a hardware solution (which is normally a better one) but I don not want to open up the Mac again unless i'll put an extra SSD in it in the future. The NZXT Sentry LX is a larger dual bay fan controller and comes with a RGB led display to match. The fan will blow full speed at start up but stops once you activate the application. Compatible with Mac and Windows With Seagate. So in case you replace your HDD with SSD, which don't have the connector) you can let the HDD fan depend on the ODD sensor and leave the ODD (and LCD) controlled by the system. The Seagate Backup Plus Hub desktop drive is the simple way to protect and share your entire digital life. I just opened the iMac up now and was planning on installing a 3.5 disk drive again so I can have the temperature sensor work once again, but there doesn't seem to even be a temperature sensor cable to plug into this.ĭoing a little research I found that some models apparently didn't have a sensor and instead had firmware on the drive itself to give the readings? But this isn't a stock Harddrive that I'm installing, so it won't have the firmware.Īny idea what to do here? Is there a place on the board to plug in a temperature cable? I see the cables on eBay (for 2011 iMacs), but mine doesn't have the cable and I doubt the previous owner removed it.ġ.) is there a place to connect this sensor?Ģ.) is there a way to put the firmware on the drive?Ģ.5) if I'm able to put the firmware on the Harddrive, would that need to be my boot drive in order to work for the sensor? I was going to use it as a storage drive.This is a very good working software, you can leave the thermal sensor unplugged and let the fan depend on one of other sensors, and you can choose if the software or the system itself determines when the fan should blow. ![]() ![]() Our easy guide makes getting the right drive easy + install videos & phone support ensure success. Add capacity, performance, & reliability ‘in a flash’ with an SSD upgrade kit from OWC. When I got this iMac it already had an SSD installed into the main drive and the previous owner installed a fan control program due to the new Harddrive not being able to do temperature control. OWC Internal Solid-State Drive (SSD) Upgrade Kits.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |